BittWare XUP-VV8 FPGA Accelerator Card

BittWare XUP-VV8 FPGA Accelerator Card features the Xilinx FPGA in a 3/4-length PCIe board, including QSFP-DD (double-density) cages for maximum port density. The XUP-VV8 supports up to 8x 100GbE or 32x 10/25GbE using the Virtex UltraScale+ VU13P or VU9P FPGA. The FPGA provides large logic resources, up to 3.8M logic cells, as well as 455Mb of embedded memory.

The BittWare XUP-VV8 FPGA Accelerator Card offers a jitter cleaner to support synchronous ethernet. If external memory on the DIMMs is not required, the board can be configured as single width.

Features

Four QSFP-DD for up to 8x 100GbE
Air or liquid cooled
Up to 3.8M logic cells and 455Mb embedded RAM

Specifications

FPGA
- Virtex UltraScale+
- VU9P or VU13P in D2104 package
- Core speed grade – 2
On-board Flash
- Flash memory for booting FPGA
External memory
- 4 DIMM sites, each supporting:
  - Up to 128 GBytes DDR4 x72 with ECC
  - Up to 576 Mbits dual QDR-II+ x18 (2 independent 288Mbit banks)
Host interface
- x16 Gen3 interface direct to FPGA
USB ports
- Micro USB: access to BMC, FPGA JTAG, and FPGA UART
Timestamp
- 1 PPS input and 10MHz clock input
OCuLink
- 2 OCuLink on the rear edge, each connected to FPGA via 4x GTY transceivers
QSFP cages
- 4 QSFP-DD cages on front panel
- Each supports 2x 100GbE, 2x 40GbE, 8x 25GbE, or 8x 10GbE
- Jitter cleaner for network recovered clocking
Cooling
- Dual-width passive heatsink – standard
- Single-width passive heatsink – optional (Available on boards with no external memory)
- Dual-width active heatsink – optional
- Dual-width liquid cooling – optional

Board Management Controller
- Voltage, current, and temperature monitoring
- Power sequencing and reset
- Field upgrades
- FPGA configuration and control
- Clock configuration
- I²C bus access
- USB 2.0
- Voltage overrides
Electrical
- On-board power derived from a 12V PCIe slot & two AUX connectors (8-pin)
- Power dissipation is application-dependent
Environmental
- +5°C to +35°C operating temperature range
Form factor
- 3/4-length, standard-height PCIe dual-width board
- Single-width option (Available on boards with no external memory)
- 10in x 4.37in (254mm x 111.15mm)
System development
- BittWorks II Toolkit – host, command, and debug tools for BittWare hardware
FPGA development
- FPGA Examples – example Vivado projects, available with the BittWorks II Toolkit
- Xilinx Tools – Vivado^® Design Suite

BittWare XUP-VV8 FPGA Accelerator Card

Features

Specifications

Block Diagram

Videos

husseinkey ELECTRONICS®

COMPANY